External
Bonding Liquidtight Flexible Metal Conduit Connectors
 |
|
| Application |
- Used
where external bonding jumper is
required around liquidtight flexible metal
conduit
|
- To
positively bond conduit to box or
enclosure
|
- Used
where flexible raceway is installed
in outdoor or indoors location where
exposed to continuous or intermittent
moisture
|
| |
| Features |
 |
- Designed with provision to install
bonding jumper
in several positions
- Designed to accept mechanical or
compression lug
- Ability to install quickly with low
torque effort
-
Compressed
metallic convolutions; assures
ground contact with low impedance and high
raceway holding power (A)
-
Single
helical thread on ground cone is easy
to install without cross thread; accepts
variations in raceway diameters and
convolution pitch (B)
-
Rolled
over edge protects con-ductors (C)
- Patented sealing ring design has
following
exclusive features:
-
Grips
and seals at leading and trailing
edge—will not abrade raceway jacket (D)
-
Provided
with grooves on inside diameter for
anti-sleeving (E)
-
Shoulders
on both ends for extra sealing (F)
-
Symmetrical
shape assures fool-proof
assembly
- Can be disconnected and reused
- Watertight/oiltight installation at box
or enclosure
termination is assured by:
-
External
taper thread hub on 5331GR series
and use of seal-ing gasket 5262 series (G)
-
Taper
tapped hole on 5271 series
- Suitable for use in Class I Division 2,
Class II
Division 1 & 2 and Class III Division 1 & 2
Hazardous Locations per NEC Article 500
- Suitable as a bonding means per U.L. 467
and
NEC Article 351-9
- Conforms with JIC requirements
|
Standard Material
Lugs: High
conductivity copper (for copper conductor only).
Body, Gland, Locknut & Ground Cones: All steel or malleable
iron.
Sealing Ring and Insulator: All thermo-plastic.
Sealing Gasket: Stainless Steel and Buna N.
Strap: Steel.
Standard Finish
All Electro Zinc
Plated and Chromate Coated except lugs.
Lugs: Bright Dipped.
Listed/Certified by:
U.L. File
#E-23018 CSA.
Conforms to:
U.L. 467,
U.L. 514, CSA C22.2 No. 18, CSA22.2 No. 41, NEMA FB-1, ANSI
C33.84, NFPA 70-1979 (ANSI), JIC EGP1, JIC EMP1, Federal
Specification W-F-406, Federal Standard H-28 (threads).
